The two-minute tutorial
Watch it once and you'll have it. Add your video in the theme editor when it's ready.
The quick answers
Applying your brows
Start with clean, dry skin
Wash and fully dry the brow area. Skip moisturizer, oils and sunscreen where the transfer will sit — they stop it gripping.
Cut out your brow
Trim closely around the brow shape. Do one brow at a time so you can line up the second to match.
Peel off the clear film
Remove the transparent top layer, then place the brow face-down exactly where you want it.
Press with a damp cloth
Hold a wet cloth firmly against the backing for about 30 seconds. Press, don't rub — make sure the edges get fully wet.
Peel the backing away
Slide the paper off slowly. If any part lifts, lay it back down and hold the damp cloth a few seconds longer.
Let it set
Give it a couple of minutes to dry before touching, and try not to get it wet for the first hour. Set with translucent powder if you'd like extra hold.
Getting the best results
Removing them
Oil-based makeup remover, coconut oil or baby oil on a cotton pad. Let it sit for 20 seconds, then wipe gently. Never scrub.
Making them last longer
Avoid oily skincare directly on the brow, pat dry instead of rubbing after showers, and dust with translucent powder to cut shine.
Getting them even
Line the inner edge up with the side of your nose and check in the mirror before you press. Apply one, step back, then do the second.
If an edge lifts
Press a damp cloth over it again for a few seconds. Most lifting happens because that spot didn't get fully wet the first time.
How To Apply
Start with the Variety Pack
Now that you know how they work, the Variety Pack is the easiest place to begin.
- Try every shape in one pack
- The easiest way to find your match